How to Assemble The Other Side Devouring Eel

Quick Answer

Assemble the Devouring Eel by dry-fitting the preassembled parts, applying thin plastic glue, and using a hobby knife to clean mold lines before painting.

Step-by-Step Assembly Guide

1. Clean the parts: Use a hobby knife or fine sandpaper to remove mold lines and flash from the preassembled miniature. Pay extra attention to the body segments and the mouth area. Check for leftover sprue nubs in hard-to-reach spots before priming.
2. Dry-fit the pieces: Before applying glue, hold the parts together to see how they align. The Devouring Eel's body may have subtle curves that need adjusting to sit flush. If a joint doesn't fit snugly, sand the contact surfaces gently rather than forcing glue.
3. Glue with thin plastic cement: Apply a small amount of plastic glue to the joint surfaces and press firmly for 30 seconds. Avoid using too much, as excess glue can mar the surface texture. Use a toothpick to apply glue precisely and wipe away any excess immediately.
4. Prime the model: After the glue dries, prime the miniature with a rattle can or airbrush. Choose a primer color that matches your base coat—grey works well for most schemes. Prime in a well-ventilated area and hold the can 15-20 cm away to avoid pooling.
5. Paint in sub-assemblies if needed: If you plan to paint the mouth or underbelly separately, keep those parts unglued until after painting. This is especially useful for the Eel's open jaws. Use poster putty to hold parts temporarily while painting, then glue them at the end.

Product Facts

• The Other Side: Devouring Eel: The Devouring Eel is a fast, regenerative predator that can split into additional Eels after reaching Glory. Its dynamic pose and multiple segments make careful assembly and painting essential to show off the model's movement on the tabletop.